How To: Programming and Installing your Recessed DW20R sensor

You will need a drill, and a 11/16" spade bit

Drill a hole in door at least 4' off floor or so, and then directly opposite in frame also using 11/16" bit. Doesn't matter which side sensor is in. Mark depth, and if necessary, wrap blue painters tape around mag or sensor to get a snug fit.

Hit logo at bottom right of screen
Enter installer code
System configuration
Right arrow to blank sensor location
Down arrow
(01) entry delay 1 or (02) Entry delay 2
Down arrow
(0863) dw20r
Down arrow
Learn serial (or hit shift then learn)
Pull magnet away from switch to get serial programmed
Down arrow
(0) new equip
Down arrow
Loop (1) 1
Down arrow
(0) disable dialer delay
Down arrow
Voice descriptor ("Insert", enter code; codes: http://2gig.com/pdf/product-info/Che...et(Z-WAVE).pdf)
Down arrow
(1) report enabled
Down arrow
(1) supervised enabled
Down arrow
(01) voice only
Skip
End
Exit