Results 1 to 2 of 2

Thread: Garbage screen after 1st programming and reboot

  1. #1
    Junior Member
    Join Date
    Oct 2015
    Location
    St. Louis
    Posts
    10

    Garbage screen after 1st programming and reboot

    I am installing my 2nd 2GIG Go Control GC2 system in a new house.

    I'm leaving my current system for my son here or I would just take this one with me.

    I'm running into an issue during installation.

    I had only got one sensor programmed and I went too far and the system rebooted.

    After this, it was stuck in a "reboot loop" and would never say "System Disarmed" but the screen would flash a couple of times, display the image below pause for a few seconds and reboot. Once it came back it would do the same thing. Flash a couple of times, display the garbage, reboot.

    Click image for larger version. 

Name:	IMG-4395.jpg 
Views:	4 
Size:	23.7 KB 
ID:	529

    After double checking all connections etc, I removed the cellular module and my system is working normally. I've programmed a few sensors and key fobs and can arm and disarm.

    I haven't tried reinserting the cellular module again.

    Is this a sign of something failing on the cell module?

    Thanks in advance.

  2. #2
    Junior Member
    Join Date
    Oct 2015
    Location
    St. Louis
    Posts
    10
    No suggestions here?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •