Configuring GoControl FS20Z-1

[Christian]

Does anyone have any experiences adding this to a 2GIG gc2 panel?

I was able to remove it from the factory network, but not able to include it in my home network?

[Alarm10]

Does anyone have any experiences adding this to a 2GIG gc2 panel?

I was able to remove it from the factory network, but not able to include it in my home network?

Please try the following steps:
1. Prepare the controller to include a unit to the network, by adding it to a group. Refer to Controller instructions.
2. The FS20Z-1 must be in its permanently installed location. Press the button on the FS20Z-1 once.
3. You should see an indication on your Controller that the "Device Was Included" in the network.

You said you removed it from the factory network. Just double-check that it was deleted.