Results 1 to 2 of 2

Thread: Smoke detector not reporting with test button

  1. #1

    Smoke detector not reporting with test button

    I have a smkt3-345 that learned the serial number and reports when I tamper the detector. However when I press the test button no alarm reports to the panel. Any ideas? As always any help or ideas are appreciated

  2. #2
    Quote Originally Posted by tckwilson View Post
    I have a smkt3-345 that learned the serial number and reports when I tamper the detector. However when I press the test button no alarm reports to the panel. Any ideas? As always any help or ideas are appreciated
    Testing
    Before testing, put the panel into test mode so the central station is not notified to prevent
    unwanted alarms. Testing the alarm activates an alarm sound and sends a signal to the Control
    Panel. The test function cannot be used if the alarm has a trouble condition.
    Test alarm sounder, LEDs and transmitter
    1.Hold the Test button for 4 beeps (approximately 6 seconds).
    2.Release the Test button.
    3.Once released, the product will continue to beep 5 more times. Before the beeps stop, a
    signal will be sent triggering the alarm.
    Smoke Test
    Hold a cotton wick at the side of the alarm and gently blow smoke through the alarm until the
    smoke triggers the alarm. You can also use smoke aerosol.
    Direct Heat Test (Use Hair Dryer 1000‐1500 Watts)
    Direct heat toward the alarm. Hold the heat source about 12 inches from the alarm to avoid
    damage to the plastic. The alarm resets only after it has time to cool
    Michael Ferer
    www.buy2gig.com
    "The Source For 2GIG and Alarm.com Plans"
    1-877-661-8941

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •