Results 1 to 3 of 3

Thread: GC3 with Linear Z wave garage door controller GD00Z-4

  1. #1

    GC3 with Linear Z wave garage door controller GD00Z-4

    Does anyone know if I can use the GD00Z-4 I just purchased with the GC3? When I add it via Z-wave, it just comes up as an unknown device. It also came with a wireless tilt sensor, but not sure If I have to add the tilt sensor seperately?

  2. #2
    Quote Originally Posted by ryangunther View Post
    Does anyone know if I can use the GD00Z-4 I just purchased with the GC3? When I add it via Z-wave, it just comes up as an unknown device. It also came with a wireless tilt sensor, but not sure If I have to add the tilt sensor seperately?
    As per Nortek the Panel does not have the capability.. YET. They are expecting a future firmware update to enable the capability, but no release date announced.

  3. #3
    I heard from technicians that it will, if it doesn't today. Fun fact, the GDO is a Zwave Plus module, which GC3 supports. Zwave Plus has better power management and better range. Fitting they would figure this out since 2GIG stands for 2 guys in a garage and there's a garage for its logo.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •