Results 1 to 3 of 3

Thread: How to Install and walktest pir motions (2GIG-PIR1) and image sensors (2GIG-IMAGE1)

  1. #1
    Senior Member
    Join Date
    Feb 2014
    Location
    WV
    Posts
    385

    How to Install and walktest pir motions (2GIG-PIR1) and image sensors (2GIG-IMAGE1)

    Install motions at 7.5' - 8', do not install so they are looking at windows, or near heating vents, or bathrooms, set sensitivity jumper to high

    Note regarding Image sensors
    ADC has multiple versions of the Image Sensor for use with various panels (GE/Interlogix Simon XT/XTi, Qolsys, and 2GIG GC, each using custom firmware).

    ONLY use the firmware versions made for 2GIG (example: ADC-IS-100-GC, or ADC-IS-200-GC). "GC" denotes it is for the Go!Control panel.
    Recommend programming as interior followers (04) zone type

    Descriptor cheat sheet. To enter descriptors, hit 'insert', then enter code for word, then 'next', and 'insert', enter code for next word.
    http://2gig.com/pdf/product-info/Che...et(Z-WAVE).pdf

    Installation/Programming:
    Hit logo, bottom right screen corner
    Enter Installer code
    system config

    Right arrow till you see empty line
    Hit down arrow
    Change (00) unused to (04) Interior follower
    Down arrow
    Change to (2) motion
    Down arrow
    Enter (0869) pir, or (9999) Image Sensor
    Down arrow
    Learn (on serial screen hit shift, then learn)
    (On pir1 push tamper switch, otherwise, put batteries in IS
    If learn fails, hit learn again, on image sensor, insert toothpick into hole and push, hold it for 15 sec or so. IS must be reset if it has previously been learned to any panel
    Wait for pair (on IS, a single digit may appear e.g., '5'), select 'OK'),
    Down arrow
    Equip age (0) new
    Down arrow
    Loop (1) 1
    Down arrow
    Dialer delay (0) disabled
    Down arrow
    Enter voice descripter (see cheat sheet for descriptor word codes, then click "Insert", enter code)
    Down arrow
    Reports (1)enabled
    Down arrow
    Supervised (1)enabled
    Down arrow
    Chime (00)disabled
    Skip
    End
    Exit
    Last step for image sensor setup

    applies only if 'initialization is incomplete'

    Then have your provider resend the image sensor rules via ADC backend

    Performing a WalkTest, to verify all PIR1, and image Sensors are properly installed, and functioning

    NOTE regarding Image Sensors

    After you test the functionality of the PIR motion functionality of the Image Sensor, you need to setup/test/position the IR still camera aspect.

    Here is how: http://www.2gigforum.com/threads/9-A...tion-Code-quot

  2. #2

    Installing 2GIG PIR Motion Detectors

    Nice demo of the walk test. Also, as a reminder to others out there, be aware of how animals (especially cats!) might impact your use of PIR motions.


  3. #3
    Senior Member
    Join Date
    Feb 2014
    Location
    WV
    Posts
    385
    Updated post #1 with 2GIG IS model#

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •