Installing/programming 2GIG combined shock/glass break/window sensor. You can get them here SuretyDIY.

Two zones...one zone for window, and the other for shock/glass break detection


Programming window sensor zone (for example, descriptor would be "living room window")
Hit logo at bottom right of screen
Enter installer code
System configuration

Right arrow to blank sensor location
Down arrow
(03) perimeter
Down arrow
(0862) dw10
Down arrow
Learn serial (or hit shift then learn)
Pull magnet away from switch to get serial programmed
write down the serial number, will need it later
Down arrow
(0) new equip
Down arrow
Loop (2) 2
Down arrow
(0) disable dialer delay
Down arrow
Voice descriptor ("Insert", enter code..see Descriptor codes)
Down arrow
(1) report enabled
Down arrow
(1) supervised enabled
Down arrow
(01) voice only
Down arrow
Summary screen
Edit next

Programming shock/glass break zone (for example, descriptor would be "living room glass break")

Down arrow
(03) perimeter
Down arrow
(0862) dw10
Down arrow
Enter serial number that you wrote down
Down arrow
(1) existing
Down arrow
Loop (1) 1
Down arrow
(0) disable dialer delay
Down arrow
Voice descriptor
Down arrow
(1) report enabled
Down arrow
(1) supervised enabled
Down arrow
(01) voice only

Skip
End
Exit