Install Resolution tilt sensor on inside of Garage Door vertically with the decorative lines at the bottom. Install sensor at top of garage door.



Note- Resolution tilt sensors are prone to false alarming!
For alternative to a tilt sensor using a dw10 and a waterproof garage door reed switch, see:
http://www.2gigforum.com/threads/61-...(using-a-DW10)
Installation/programming for Resolution RE206
Hit logo at bottom right of screen
Enter installer code
System configuration

Right arrow to blank sensor location
Down arrow
*(02) exit/entry 2
Down arrow
(1061) GARAGE01 Resolution products tilt sensor
Down arrow
Learn serial (or hit shift then learn)
Activate tamper to get serial programmed
Down arrow
(0) new equip
Down arrow
Loop (2) 2
Down arrow
(0) disable dialer delay
Down arrow
Voice descriptor ("insert", enter code...example 'Garage Door' code is "101" and "058" for all codes see: Descriptor codes)
Down arrow
(1) report enabled
Down arrow
(1) supervised enabled
Down arrow
(01) voice only
Skip
End
Exit
* Q7 exit/entry 2 is 45 seconds, this can be change to whatever you need it to be. To optimize Q settings see: http://www.2gigforum.com/threads/5-2...panel-settings