How to install and program a 2GIG Doorbell

Descriptor codes: (e.g., "front door" would be 098 then 058):
http://2gig.com/pdf/product-info/Che...et(Z-WAVE).pdf

Hit logo at bottom right of screen
Enter installer code
System configuration
Right arrow to blank sensor location, then down arrow (then down arrow again after each section)
(23) no response
Down arrow
(1) contact
Down arrow
(1063) DBELL1
Down arrow
Learn serial (shift then learn, activate doorbell, then 'ok')
Down arrow
(0) new equip
Down arrow
Loop (1) 1
Down arrow
(0) disable dialer delay
Down arrow
Voice descriptor ("insert", enter code)
Down arrow
(0) report disabled
Down arrow
(1) supervised enabled
Down arrow
(1-13) for chime/voice selection
Skip
End
Exit