PDA

View Full Version : Installing/Programming keyfobs (2GIG-KEY2)



rive
06-05-2014, 09:09 AM
The panel supports up to 8 remotes (keyfobs).





Hit logo at bottom right of screen
Enter installer code
System configuration
Select "go to", enter (03) for Q3 keyfobs
Use right arrow, select empty fob #, then down arrow (then down arrow again after each section)
(01) Fob used/enabled
(0866) Key2
Learn serial (shift then learn, hold in button keys, then 'ok')
(0) new equip
Select emergency fob function:
(0) disabled; (1) auxilary alarm; (2) audible alarm; (3) silent panic; (4) fire
Select if fob can disarm:
(0) disabled; (1) enabled
Voice descriptor
Select arming no delay:
(0) disabled; (1) enabled
Select fob key 4 output: (disable unless using a garage door/GDR output)
(0)disabled; (1) toggle output; (2) momentary output
Next to program another fob, else
Skip
End
Exit

Amanda
06-09-2014, 11:14 AM
For a visual in case that helps anyone new to the programming to follow rive's instructions.


https://www.youtube.com/watch?v=RZmsDJqFeoQ

beerluvr
12-03-2014, 07:00 PM
Can the 2gig keyfob unlock and lock kwikset door locks? any help would be great

dex
12-03-2014, 08:03 PM
if you have it set to say unlock when you disarm the system from away i think that is possible but rive would know more about it then me.

Jacksonlee
11-26-2016, 03:38 AM
The panic can be activated by pressing and holding the away and disarm buttons. The auxiliary button will only trigger the panel's trigger output terminals.
Locksmith in Davie (http://www.locksmithdavie.co/)